MOLLE Generator
UKEN
Open the generator

Vehicle fit

Toyota 4Runner

Cargo area side panel, 2010+. 420 × 280 mm. Uses the factory cargo tie-down points.

Sketch built from the panel parameters
VehicleToyota 4Runner, 2010+
Mounting locationCargo area side panel
Panel size420 × 280 mm
GridPALS standard — 38.1 mm horizontal, 25.4 mm row pitch
Suggested material4 mm HDPE, 4 mm plywood or 3 mm aluminium
Open this panel in the generatorAll vehicles
draft. Draft dimensions: not yet measured on a physical vehicle. Print the outline, offer it up and adjust before cutting. Measured one yourself? Send the numbers and we will publish them with your credit.

How to fit it

  1. Open the size above — the generator loads with these dimensions already set.
  2. Print the outline at 100% and offer it up, marking the real obstructions: wiring, trim clips, curvature.
  3. Adjust width, height and margins, add perimeter holes where the factory anchor points are.
  4. Export the DXF, cut, deburr the slot edges. Mount to factory anchor points rather than drilling new ones where you can.