MOLLE Generator
UKEN
Open the generator

Vehicle fit

Ford Bronco

Cargo area side panel, 2021+. 380 × 300 mm. Four-door cargo bay, driver side. Clears the rear wheel arch.

Sketch built from the panel parameters
VehicleFord Bronco, 2021+
Mounting locationCargo area side panel
Panel size380 × 300 mm
GridPALS standard — 38.1 mm horizontal, 25.4 mm row pitch
Suggested material4 mm HDPE, 4 mm plywood or 3 mm aluminium
Open this panel in the generatorAll vehicles
draft. Draft dimensions: not yet measured on a physical vehicle. Print the outline, offer it up and adjust before cutting. Measured one yourself? Send the numbers and we will publish them with your credit.

How to fit it

  1. Open the size above — the generator loads with these dimensions already set.
  2. Print the outline at 100% and offer it up, marking the real obstructions: wiring, trim clips, curvature.
  3. Adjust width, height and margins, add perimeter holes where the factory anchor points are.
  4. Export the DXF, cut, deburr the slot edges. Mount to factory anchor points rather than drilling new ones where you can.